Installation Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Speaker Components
    GM892621Courtesy of GENERAL MOTORS CORP.
  1. Install the upper locating tabs for the speaker base into the slots (4) on the inner door panel.

    Push the speaker assembly (3) upward to engage the locating tabs.

  2. Align the lower retaining tab (2) for the speaker base into the slot (4) on the inner door panel.

    Press the lower retaining tab (2) into the inner door panel until fully engaged.

  3. Connect the electrical connector (1).
  4. Install the speaker wire harness rosebud retainer to inner door panel.
  5. Install the door trim panel. Refer to Trim Panel Replacement - Side Front Door in Doors.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.