Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1323 (MANUAL TRANSMISSION - MK5 - INTRODUCTION)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Fastener Tightening Specifications
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Backup Lamp Switch | 40 N.m | 30 lb ft |
| Clutch Line Bracket Bolts | 25 N.m | 18 lb ft |
| Clutch Release Cylinder Bolts | 12 N.m | 9 lb ft |
| Drain Plug | 39 N.m | 29 lb ft |
| Fill Plug | 39 N.m | 29 lb ft |
| Ground Cable Bolts | 13 N.m | 10 lb ft |
| Left Transaxle Mount Bracket Bolts | 52 N.m | 38 lb ft |
| Left Transaxle Mount Bolts | 52 N.m | 38 lb ft |
| Left Transaxle Mount Through Bolt | 80 N.m | 59 lb ft |
| Lock Ball Assembly | 29 N.m | 22 lb ft |
| Lower Transmission to Engine Bolts | ||
|
64 N.m | 47 lb ft |
|
47 N.m | 35 lb ft |
|
23 N.m | 17 lb ft |
| Shift Lever Shaft Assembly | 19 N.m | 14 lb ft |
| Starter Wire Nut | 10 N.m | 87 lb in |
| Starter Motor Retaining Bolts | 37 N.m | 28 lb ft |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.