SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1317 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSFOG LAMP REPLACEMENT - FRONTINSTALLATION PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Installation Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Fog Lamp Bulb
    GM624038Courtesy of GENERAL MOTORS CORP.
  1. Install the fog lamp bulb to the fog lamp, turning clockwise, if required.
    2. Fig 2: Fog Lamp And Front Bumper Fascia
    GM820583Courtesy of GENERAL MOTORS CORP.
  2. Install the fog lamp (1) to the front bumper fascia (2).
    3. Fig 3: Lower Splash Shield, Push Retainer And Screws
    GM820581Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the fog lamp.
  4. Install the two screws (1) and the push retainer (3) to the front lower splash shield (2).
  5. Lower the vehicle.
  6. Check and adjust the fog lamp aim as necessary. Refer to Fog Lamp Aiming Procedure .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.