Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1315 (CRUISE CONTROL SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDIAGNOSTIC TROUBLE CODE (DTC) DISPLAYINGFLASH CODE DIAGNOSTICSDISPLAYING FLASH CODES USING A JUMPER WIRE.
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Displaying Flash Codes using a Jumper Wire.
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Displaying Flash Codes using a Jumper Wire.
WARNING: This page is about a different car, the 2004 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
Connect a jumper between cavity 4 and cavity 13 with the ignition ON, and the engine OFF. This action pulls the cruise control module (CCM) terminal 10 to ground and signals the CCM to enter the FLASH DTC diagnostic display mode.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.