Removal Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front side door trim. Refer to TRIM PANEL REPLACEMENT - SIDE FRONT DOORΒ  .
  2. Pull back the water deflector in order to gain clearance to remove the front door check link from the door.
  3. Remove the following components from the vehicle:
    • The front door check link to door jamb bolt (3)
    • The 2 bolts (2) that retain the check link to the rear door
    • The check link (1) through inner door panel access hole
Fig 1: Removing Front Door Check Link To Door Jamb Bolt And Check Link To Rear Door Retaining Bolts
G01434674Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.