SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1295 (WIPER SYSTEM & WASHER SYSTEM)REPAIR INSTRUCTIONSWASHER SOLVENT CONTAINER REPLACEMENTREMOVAL PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Removal Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right side fender flare. Refer to FLARE REPLACEMENT - FRONT FENDER in Exterior Trim.
  2. Remove the right side wheel house panel. Refer to WHEELHOUSE PANEL REPLACEMENT in Body Front End.
  3. Disconnect the 2 washer pump electrical connectors (1).
  4. Disconnect the washer pump hoses (4) from the washer pumps (3).
  5. Remove the 3 bolts which secure the windshield washer solvent container (2).
  6. Squeeze tabs on filler neck and pull down to remove washer solvent container (2) from vehicle.
  7. Drain solvent from washer solvent container (2).
  8. Remove the washer pumps (1) from the washer solvent container (2).
    Fig 1: Removing Washer Solvent Container
    G01433830Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.