Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Scan Tool Data Definitions
PNP Switch: This parameter indicates the range selection of 3 speed or 4 speed automatic transmission equipped vehicles. The parameter will display Park/Neutral for the Park or Neutral position of the gear selector. The parameter will display In Gear for the Reverse, Drive, or Low positions of the gear selector.
Starter Switch: This parameter displays ON when the powertrain control module (PCM) is receiving a signal indicating that the engine starter motor is cranking.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.