SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1252 (INSTRUMENT PANEL, GAGES, AND CONSOLE)SPECIFICATIONSFASTENER TIGHTENING SPECIFICATIONS
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Fastener Tightening Specifications

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Fastener Tightening Specifications
WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications

Application Specification
Metric English
Front Floor Console Armrest Hinge Screw 2 N.m 18 lb in
Front Floor Console at Rear of Storage Compartment Base Bolt 12 N.m 106 lb in
Front Floor Console Bolt 2 N.m 18 lb in
Front Floor Console Bracket Rear of Transaxle Shift Lever Bolt 5 N.m 44 lb in
Front Floor Console Center Bolt 5 N.m 44 lb in
Front Floor Console Rear Bolt 5 N.m 44 lb in
Head Up Display Module Bolt 2 N.m 18 lb in
Instrument Cluster HUD Bolt 2 N.m 18 lb in
Instrument Cluster Lens Screw 1 N.m 9 lb in
Instrument Panel Ashtray Bracket Screw 2 N.m 18 lb in
Instrument Panel Cluster Screw 2 N.m 18 lb in
Instrument Panel Compartment Door Screw 1 N.m 9 lb in
Instrument Panel Compartment Hinge Screw 2 N.m 18 lb in
Instrument Panel Compartment Latch Screw 1 N.m 9 lb in
Instrument Panel Compartment Striker Screw 2 N.m 18 lb in
Instrument Panel Lower Bolt 2 N.m 18 lb in
Instrument Panel Trim Pad at Cluster Pocket Bolt 5 N.m 44 lb in
Instrument Panel Trim Pad Mounting at Windshield Bolt 5 N.m 44 lb in
Instrument Panel Trim Pad to Compartment Bolt 2 N.m 18 lb in
Knee Bolster Bracket Bolt at IP 2 N.m 18 lb in
Knee Bolster Bracket Bolt at Steering Column Support 10 N.m 89 lb in
Steering Column Opening Filler Bolt 2 N.m 18 lb in
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.