SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1214 (POWER STEERING SYSTEM)REPAIR INSTRUCTIONSPOWER STEERING PULLEY REPLACEMENT (3.1 L)INSTALLATION PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Installation Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • Never use a hammer to install the power steering pulley.
  • The face of the power steering pulley hub must be flush with the end of the power steering pump driveshaft.
  1. Using J 25033-C  install the power steering pump pulley to the power steering pump.
  2. Install the accessory drive belt. Refer to DRIVE BELT REPLACEMENT .
  3. Fill the power steering system. Refer to Checking and Adding Power Steering Fluid .
  4. Bleed the power steering system. Refer to Bleeding the Power Steering System .
  5. Inspect the power steering system for leaks. Refer to Power Steering Fluid Leaks .
    Fig 1: Installing Power Steering Pump Pulley
    G01672988Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.