Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1206 (BODY FRONT END)REPAIR INSTRUCTIONSHOOD REPLACEMENTREMOVAL PROCEDURE

2003 Chevrolet TrailBlazer 4.2 S, 4WD

Removal Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: When removing body panels, apply tape to corners of panel and adjacent surfaces to help prevent paint damage.

Disconnect the under hood light electrical wire connector located on the passenger side front of the lower radiator support.

Fig 1: Disconnecting Under Hood Light Electrical Wire Connector
Courtesy of GENERAL MOTORS CORP.
Mark the location of the hinges on the frame rails using a grease pencil.
With the aid of a helper, support the hood assembly.
Remove the struts from the upper ball studs.
Pry outward on the retaining clip and pull the strut from the ball stud.

Fig 2: Removing Struts From Upper Ball Studs
Courtesy of GENERAL MOTORS CORP.
Remove the nuts attaching the hinge to the frame rail.

Fig 3: Removing Nuts Attaching Hinge To Frame Rail
Courtesy of GENERAL MOTORS CORP.
Remove the hood.
Transfer parts as necessary.

Fig 4: Hood
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.