Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
- Install the antenna bezel to the quarter panel, if removed.
Align the locating tab on the antenna bezel to the notch in the quarter panel, then insert the bezel and push to secure.
- Carefully install the fixed antenna to the vehicle through one of the tail lamp openings.
- Apply sealer to the groove on the antenna coaxial cable grommet.
- Apply a light coating of lubricant to the narrow end of the antenna coaxial cable grommet to aid in seating the grommet.
- Install the antenna coaxial cable and grommet through the opening in the rear compartment panel toward the inside of the vehicle.
- Fully seat the antenna coaxial cable grommet to the rear compartment panel.
- Position the antenna upright, toward the RR tire and align the top of the antenna with the opening in the antenna bezel.
- Install the antenna to the bezel.
Insert the antenna up through the opening in the bezel, then check that the antenna and the bezel are seated properly.
- Position the antenna and install the antenna onto the mounting studs.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.