SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1194 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSHIGH MOUNTED STOP LAMP REPLACEMENTINSTALLATION PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Installation Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the high-mounted stop lamp into position inside the rear fascia.
  2. Loosely install the stop lamp mounting screws.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Align the stop lamp to the rear fascia, then press and hold the lamp to the fascia for flushness.

    Tighten 

    Tighten the high-mounted stop lamp retaining screws to 4 N.m (35 lb in).

    Fig 1: Loosely Installing Stop Lamp Mounting Screws
    G01453390Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector to the stop lamp.
  5. Install the inner tail lamp. Refer to TAIL LAMP REPLACEMENT  . 
    Fig 2: Connecting Electrical Connector To Stop Lamp
    G01453391Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.