Inline Harness Connector End Views: C352

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION C352
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
C352 Connector End View

GM866168Courtesy of GENERAL MOTORS CORP.
GM646210Courtesy of GENERAL MOTORS CORP.
Connector Part Information
  • 12191371
  • 6-Way F Metri-Pack 280 Series Flexlock (BLK)
  • 12191370
  • 4-Way F Metri-Pack 150 Series (BLK)
Connector Part Information
  • 12191369
  • 10-Way M Metri-Pack (BLK)
Pin Wire Color Circuit No. Function Pin Wire Color Circuit No. Function
A PPL 171 Power Window Master Switch Right Rear Down Signal A PPL 171 Power Window Master Switch Right Rear Down Signal
B GRY 295 Door Lock Actuator Lock Control B GRY 295 Door Lock Actuator Lock Control
C PNK 775 Side Door Jamb Switch Signal C PNK 775 Side Door Jamb Switch Signal
D DK BLU 1307 Power Window Master Switch Lockout Signal D DK BLU 1307 Power Window Master Switch Lockout Signal
E TAN 294 Door Lock Actuator Unlock Control E TAN 294 Door Lock Actuator Unlock Control
F LT GRN 170 Power Window Master Switch Right Rear Up Signal F LT GRN 170 Power Window Master Switch Right Rear Up Signal
G LT BLU 115 Right Rear Speaker Output (-) G LT BLU 115 Right Rear Speaker Output (-)
H BLK 750 Ground H BLK 750 Ground
J DK BLU/WHT 727 Door Ajar Switch Signal J DK BLU/WHT 727 Door Ajar Switch Signal
K DK BLU 46 Right Rear Speaker Output (+) K DK BLU 46 Right Rear Speaker Output (+)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.