SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1102 (PERSONALIZATION SYSTEMS)DESCRIPTION AND OPERATIONDRIVER PERSONALIZATIONPROGRAMMING FEATURES WITH THE DRIVER INFORMATION CENTER (DIC)EXIT PROGRAMMING
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Exit Programming

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Exit Programming
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

When the programming is complete, PERSONALIZATION SELECTION DONE appears on the display. The DIC then displays PRESS SET TO EXIT then PRESS MODE TO CONTINUE. Any of the following conditions cause the programming to end before the list is complete:

  • The programming timer of one minute expires.
  • The vehicle is shifted out of PARK.
  • The ignition is moved from the RUN position.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.