Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 107 (SHIFT INTERLOCK SYSTEMS)REMOVAL & INSTALLATIONFLOOR CONSOLEINSTALLATION
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Floor Console: Installation
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Position the center console to the vehicle. Adjust the parking brake to the or fully engaged position. See Fig 1 . Connect the electrical connectors as necessary.
- Lower the rear of the console and slide the console forward into position. Ensure the 2 retaining ears on the front extensions of the console are fully engaged to the lower instrument panel (Bravada only).
- Install the center console retaining screws. Tighten the screws to 22 INCH lbs. (2.5 N.m). Install the console storage bin. See FLOOR CONSOLE STORAGE BIN .
- Install the center console shift lever bezel. Install the floor shift knob. See FLOOR SHIFT KNOB .
- Install the rubber ash tray inserts and rubber mat to the console. Remove the bocks from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.