Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR COMMUNICATION SYSTEMREPAIR INSTRUCTIONSONSTAR MICROPHONE REPLACEMENTREMOVAL PROCEDURE

2003 Chevrolet TrailBlazer 4.2 S, 4WD

Removal Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal Procedure

Remove the overhead console. Refer to OVERHEAD CONSOLE REPLACEMENT - FRONT in Interior Trim.
Disconnect the microphone electrical connector to the OnStar® microphone (1).

Fig 1: Disconnecting Microphone Electrical Connector To Onstar® Microphone
Courtesy of GENERAL MOTORS CORP.
If only the microphone removal is required, disengage the quick release tab (1) and remove the OnStar® microphone from the overhead console.
If removing the mounting bracket is required, remove the 2 retaining screws to the OnStar® microphone and remove the bracket from the overhead console.

Fig 2: Removing Bracket From Overhead Console
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.