Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXANTI-LOCK BRAKE DTCS
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Anti-Lock Brake DTCS
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Anti-Lock Brake DTCS
DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description |
|---|---|
| DTC C0221, C0222, C0223, C0225, C0226, C0227 | Front Wheel Speed Sensor Circuit |
| DTC C0229 | Drop Out of Front Wheel Speed Signals |
| DTC C0235, C0236, C0237, P0609 | Rear Wheel Speed Sensor Circuit |
| DTC C0238 | Wheel Speed Mismatch |
| DTC C0241, C0242, C0243, C0244, C0245, C0246, C0247, C0248, C0251, C0252, C0253, C0254 | EBCM Control Valve Circuit |
| DTC C0265, C0266 | EBCM Relay Circuit |
| DTC C0267, C0268 | Pump Motor Circuit Open/Shorted |
| DTC C0269, C0274 | Excessive Dump/Isolation Time |
| DTC C0271, C0272, C0273, C0284 | EBCM Malfunction |
| DTC C0279 | Powertrain Configuration Not Valid |
| DTC C0281 | Brake Switch Circuit |
| DTC C0283 | Traction Switch Shorted to Ground |
| DTC C0287, P1644, P1689 | Delivered Torque Circuit |
| DTC C0290, C0292 | Lost Communications With PCM |
| DTC C0291 | Lost Communications With BCM |
| DTC C0297 | Powertrain Configuration Data Not Received |
| DTC C0298, P1571 | Powertrain Indicated Traction Control Malfunction |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.