Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSTHEFT DETERRENT SYSTEM
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Theft Deterrent System
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Theft Deterrent System
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Starting Point - Theft Deterrent
- Diagnostic System Check - Theft Deterrent
- Scan Tool Data List
- Scan Tool Data Definitions
- Diagnostic Trouble Code (DTC) List
- DTC B2945: Short To Ground Or Open On The Passlock™ Sensor Power Circuit
- DTC B2955: BCM Signal Input Voltage
- DTC B2960: Sec Sys Sensor Data Incorrect But Valid
- DTC B3033: BCM Is Reading A Tamper Code From The Passlock™ Sensor
- DTC P1626: Theft Deterrent Fuel Enable Signal Not Received
- DTC P1630: Theft Deterrent Learn Mode Active
- DTC P1631: Theft Deterrent Start Enable Signal Not Correct
- DTC P1632: Theft Deterrent Start Disable Signal Received
- Symptoms - Theft Deterrent
- Content Theft Deterrent (CTD) Alarm Mode Inoperative
- Content Theft Deterrent (CTD) Does Not Disarm with Key Lock
- Horn Inoperative in Content Theft Deterrent (CTD) Alarm Mode
- Lights Inoperative in Content Theft Deterrent (CTD) Alarm Mode
- Security Indicator Always On or Flashing
- Security Indicator Inoperative
- Repair Instructions
- Description and Operation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.