SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003S10 PICKUP 2D PICKUP, 2.2 H, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 240 (HEATING, VENTILATION AND AIR CONDITIONING)REPAIR INSTRUCTIONSBLOWER MOTOR REPLACEMENTINSTALLATION PROCEDURE
2003 Chevrolet S10 Pickup 2D Pickup, 2.2 H, Automatic

Installation Procedure

2003 Chevrolet S10 Pickup 2D Pickup, 2.2 H, AutomaticSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Blower Motor Screws & Blower Case Assembly
    GM933076Courtesy of GENERAL MOTORS CORP.
  1. Install the blower motor to the HVAC module.
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the blower motor screws to the HVAC module.

    Tighten:  Tighten the screws to 1 N.m (9 lb in).

    3. Fig 2: Electrical Connector & Blower Motor
    GM932494Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the blower motor.
  4. Install the passenger side insulator/closeout panel. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.