2003 Chevrolet Express 1/2 Ton Van V6-4.3L VIN XFACTORY OEM SERVICE PROCEDURE

Seat Replacement



Seat Replacement

Removal Procedure

Caution: Refer to SIR Caution in Cautions and Notices.
1. Disable the Sir. Refer to SIR Disabling and Enabling Zone 3 or SIR Disabling and Enabling Zone 5 in SIR.
2. If seat is equipped with power seat motors, disconnect the electrical connector from the seat assembly.

Factory service manual diagram



3. Remove the nuts (3) that retain the seat assembly to the vehicle.
4. Remove the front seat assembly from the vehicle.



Installation Procedure


Factory service manual diagram



1. Position the front seat assembly into the vehicle.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the nuts (3).

Tighten the nuts to 60 N.m (44 lb ft).

3. Connect the electrical connector to the seat assembly, if equipped with power seat motors.
4. Enable the SIR. Refer to SIR Disabling and Enabling Zone 3 or SIR Disabling and Enabling Zone 5 in SIR.


Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.