SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 6.0 UREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALBODY ELECTRICALENGINE CONTROLS - PID VALUES, PCM CONNECTOR VIEWS AND TERMINAL IDENTIFICATIONINTRODUCTION
2003 Chevrolet Chevy Express G2500, Van Cargo Extended, 6.0 U

Engine Controls - PID Values, Pcm Connector Views And Terminal Identification: Introduction

2003 Chevrolet Chevy Express G2500, Van Cargo Extended, 6.0 USECTION Introduction
NOTE: Unless specified otherwise, information for Chevy Express and Savana applies to Cutaway, RV Cutaway, Savana Camper Special and Savana Special.

The Parameter Identification (PID) charts contain all the engine related parameters that are available on the scan tool. The list is arranged in alphabetical order. A parameter may appear in any one of the data lists, and in some cases may appear more than once, or in more than one data list in order to group certain related parameters together. Use the PID charts only after the Diagnostic System Check - Engine Controls has been completed, no DTCs were noted, and you have determined the on-board diagnostics are functioning properly. See DIAGNOSTIC SYSTEM CHECK - ENGINE CONTROLS under SELF-DIAGNOSTIC SYSTEM in appropriate SELF-DIAGNOSTICS article. Scan tool values from a properly running engine may be used for comparison with the engine you are diagnosing. The Typical Scan Data values represent values that would be seen on a normally running engine. Technical Service Bulletins (TSBs) may also be helpful in correcting a hard to diagnose problem.

NOTE: Do not use a scan tool that displays faulty data. The scan tool concern should be reported to the manufacturer. Use of a faulty scan tool can result in misdiagnosis and in unnecessary parts replacement.

If all the PID values are within the typical range and a symptom still exists, diagnosis by symptom may help find the fault. See appropriate TROUBLE SHOOTING - NO CODES article.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.