Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2003CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 6.0 UREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEEXTERIOR BODY PANELSBUMPER SYSTEMREPAIR INSTRUCTIONSSTEP PAD REPLACEMENT - REAR BUMPERINSTALLATION PROCEDURE

2003 Chevrolet Chevy Express G2500, Van Cargo Extended, 6.0 U

Installation Procedure

2003 Chevrolet Chevy Express G2500, Van Cargo Extended, 6.0 USECTION Installation Procedure

Install the step pad (1) on the bumper (4).
Align the tangs on the step pad with the slots in the bumper.
Using a rubber mallet, set the tangs in place starting at the center of the step pad and work toward each end of the pad.

Fig 1: Installing Rear Bumper Step Pad
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.