Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002VENTURE PLUSREPAIR AND DIAGNOSISRESTRAINTSAIR BAG, SRSAIR BAG RESTRAINT SYSTEMSREMOVAL & INSTALLATIONAIR BAG MODULESREMOVAL & INSTALLATION (DRIVER-SIDE)
2002 Chevrolet Venture Plus
Removal & Installation (Driver-side)
2002 Chevrolet Venture PlusSECTION Removal & Installation (Driver-side)
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM .
- Turn steering wheel so slot on rear of steering wheel is accessible. Insert Air Bag Module Remover (J43298) into holes on rear of steering wheel to release both spring loaded air bag retainers. See Figure. Turn steering wheel and use one of the fingers on air bag module remover to release cruise control lever cover. Release cruise control lever using same procedure. Turn steering wheel to access remaining slot. Release remaining driver-side air bag module retainers. Pull driver-side air bag module away from steering wheel. Make note of wiring positions when removing air bag module. See Figure.
- Remove Connector Assurance Position (CPA) clip and disconnect driver-side air bag module connector. Disconnect horn ground lead from steering wheel. Rotate horn contact lead counterclockwise 1/4 turn to release from steering wheel. Remove driver-side air bag module.
- To install, reverse removal procedure. Ensure wires are routed correctly and are not pinched during installation. Ensure driver-side air bag module and cruise control switch spring loaded retainers and fingers are seated completely. Activate air bag system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.