Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2002 Chevrolet Venture PlusSECTION Installation Procedure
- Install the PASS-Key* III module to the vehicle.
- Install the electrical connector and wires to the column.
- Slide the PASS-Key* III module over the ignition lock cylinder housing.
- Connect the electrical connector at the base to the steering column.
- Install the upper column shroud.
- Install the ignition lock Cylinder. Refer to IGNITION LOCK CYLINDER REPLACEMENT -- ON VEHICLE (CYLINDER ROTATES) or IGNITION LOCK CYLINDER REPLACEMENT -- ON VEHICLE (UNABLE TO ROTATE CYLINDER) .
- Install the IP bolster. Refer to KNEE BOLSTER REPLACEMENT .
- Program the theft deterrent system. Refer to Programming That Deterrent System Components .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.