Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2002VENTURE PLUSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALMECHANICALENGINE MECHANICAL (ON-VEHICLE)REPAIR INSTRUCTIONSENGINE OIL LEVEL SENSOR AND/OR SWITCH REPLACEMENTREMOVAL PROCEDURE

2002 Chevrolet Venture Plus

Removal Procedure

2002 Chevrolet Venture PlusSECTION Removal Procedure

Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
Drain the oil from the oil pan.
Disconnect the electrical connector from the oil level sensor.

Fig 1: Oil Level Sensor Wiring Harness Connection
Courtesy of GENERAL MOTORS CORP.
Remove the retainer bolt from the oil pan.
Remove the oil level sensor from the oil pan.

Fig 2: Oil Level Sensor
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.