Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002VENTURE PLUSREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKESANTI-LOCK BRAKE SYSTEM
2002 Chevrolet Venture Plus
Anti-Lock Brake System
2002 Chevrolet Venture PlusSECTION Anti-Lock Brake System
- Specifications
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures
- Diagnostic Starting Point - Antilock Brake System
- Diagnostic System Check - ABS
- Scan Tool Output Controls
- Scan Tool Data List
- Scan Tool Data Definitions
- Enhanced Diagnostics
- DTC C1214: System Relay Contact Or Coil Circuit Open
- DTC C1216: Electronic Brake Control Relay Coil Circuit Open
- DTC C1217: BPMV Pump Motor Relay Contacts Circuit Open
- DTC C1218: Electronic Brake Control Relay Coil Circuit Shorted To Voltage
- DTC C1221: LF Wheel Speed Sensor Input Signal Is 0; C1222: RF Wheel Speed Sensor Input Signal Is 0; C1223: LR Wheel Speed Sensor Input Signal Is 0; C1224: RR Wheel Speed Sensor Input Signal Is 0; C1225: LF Excessive Wheel Speed Variation; C1226: RF Excessive Wheel Speed Variation; C1227: LR Excessive Wheel Speed Variation; C1228: RR Excessive Wheel Speed Variation; C1232: LF Wheel Speed Circuit Open Or Shorted; C1233: RF Wheel Speed Circuit Open Or Shorted; C1234: LR Wheel Speed Circuit Open Or Shorted; C1235: RR Wheel Speed Circuit Open Or Shorted
- DTC C1236: Low System Supply Voltage
- DTC C1237: High System Supply Voltage
- DTC C1238: Brake Thermal Model Exceeded
- DTC C1242: Pump Motor Circuit Open; C1243: BPMV Pump Motor Stalled
- DTC C1254: Abnormal Shutdown Detected
- DTC C1255: EBCM Internal Malfunction; C1256: EBCM Internal Malfunction
- DTC C1261: LF Inlet Valve Solenoid Malfunction; C1262: LF Outlet Valve Solenoid Malfunction; C1263: RF Inlet Valve Solenoid Malfunction; C1264: RF Outlet Valve Solenoid Malfunction; C1265: LR Inlet Valve Solenoid Malfunction; C1266: LR Outlet Valve Solenoid Malfunction; C1267: RR Inlet Valve Solenoid Malfunction; C1268: RR Outlet Valve Solenoid Malfunction; C1271: LF TCS Master Cylinder Isolation Valve Malfunction; C1272: LF TCS Prime Valve Malfunction; C1273: RF TCS Master Cylinder Isolation Valve Malfunction; C1274: RF TCS Prime Valve Malfunction
- DTC C1276: Delivered Torque Signal Circuit Malfunction; P1644: Delivered Torque Output Circuit; P1689: Traction Control Delivered Torque Control Circuit
- DTC C1277: Requested Torque Signal Circuit Malfunction; P1571: TCS PWM Circuit No Frequency
- DTC C1278: TCS Temporarily Inhibited By Pcm
- DTC C1291: Open Brake Lamp Switch Contacts During Deceleration
- DTC C1294: Brake Lamp Switch Circuit Always Active
- DTC C1295: Brake Lamp Switch Circuit Open
- Symptoms - Anti-Lock Brake System
- ABS Indicator Always On
- ABS Indicator Inoperative
- Traction Off Indicator Always On
- Traction Off Indicator Inoperative
- Repair Instructions
- Description and Operation
- Special Tools and Equipment
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.