Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2002VENTURE PLUSREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATSPOWER SEAT SYSTEMREPAIR INSTRUCTIONSSEAT CUSHION PAD REPLACEMENT - REAR (AL4 - REAR BUCKET)INSTALLATION PROCEDURE

2002 Chevrolet Venture Plus

Installation Procedure

2002 Chevrolet Venture PlusSECTION Installation Procedure

Install the rear seat cushion cover (1) to the foam pad.
Secure the rear seat cushion cover to the foam pad using retainer rings (2) and the hook and loop retainers.
Install the J retainers (1) to secure the seat cushion cover to the seat frame.

Fig 1: Installing Rear Seat Cushion Cover & Foam Pad (AL4 - Rear Bucket)
Courtesy of GENERAL MOTORS CORP.
Install the rear seat cushion to the rear seat back.

Fig 2: Installing Rear Seat Cushion Cover & Retainer Rings (AL4 - Rear Bucket)
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.