Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2002 Chevrolet Venture PlusSECTION Installation Procedure
- Install the rear seat cushion cover (1) to the foam pad.
- Secure the rear seat cushion cover to the foam pad using retainer rings (2) and the hook and loop retainers.
- Install the seat cushion cover retainers (1) to the seat frame.
- Install the rear seat cushion to the rear seat back.NOTE: Refer to FASTENER NOTICE .
- Install the recliner bolts.
Tighten
Tighten the bolts to 32 N.m (24 lb ft).
- Install the rear seat adjuster. Refer to Seat Adjuster Replacement - Rear .
- Install the seat riser. Refer to Seat Riser Replacement - Rear .
- Install the finish covers. Refer to Seat Trim Replacement - Side .
- Install the second row bucket seat. Refer to Seat Replacement - Rear .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.