Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2002VENTURE PLUSREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEEXTERIOR BODY PANELSBUMPER SYSTEMREPAIR INSTRUCTIONSIMPACT BAR REPLACEMENT - REAR BUMPERINSTALLATION PROCEDURE

2002 Chevrolet Venture Plus

Installation Procedure

2002 Chevrolet Venture PlusSECTION Installation Procedure

Fig 1: Installing Push-In Retainers & Front Energy Absorber

Courtesy of GENERAL MOTORS CORP.

Align the rear impact bar to the frame rail.
NOTE: Refer to FASTENER NOTICE .
Install the rear impact bar bolts to the frame rail.
Tighten

Tighten the bolts to 50 N.m (36 lb ft).
Install the energy absorber to the rear impact bar.

Fig 2: Installing Impact Bar Bolts & Frame Rail
Courtesy of GENERAL MOTORS CORP.
Install the push-in retainers to the rear energy absorber.
Install the rear bumper fascia. Refer to Fascia Replacement - Rear Bumper (Oldsmobile) or Fascia Replacement - Rear Bumper (Pontiac) .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.