Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2002 Chevrolet Venture PlusSECTION Removal Procedure
CAUTION:
Refer to SIR CAUTION
.
- Disable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
- Remove the steering wheel. Refer to Steering Wheel Replacement .
- Remove the tilt lever. Refer to TILT LEVER REPLACEMENT - On Vehicle .
- Remove the lower trim cover screws (1).
- Remove the lower trim cover (2) from the steering column.
- Tilt the lower trim cover down and slide the lower trim cover in order to disengage the locking tabs.
- Remove the upper trim cover screws.
- Remove the upper trim cover (2) from the steering column.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.