Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2002VENTURE PLUSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSREPAIR INSTRUCTIONSCRUISE CONTROL CABLE REPLACEMENTREMOVAL PROCEDURE

2002 Chevrolet Venture Plus

Removal Procedure

2002 Chevrolet Venture PlusSECTION Removal Procedure

Fig 1: Removing Cable From Throttle Lever & Accelerator Control Cable Bracket

Courtesy of GENERAL MOTORS CORP.

Remove the cable from the throttle lever and accelerator control cable bracket.
Rotate the cable counter clockwise at the module in order to remove the cable from the module.
Remove the cable from the module band.

Fig 2: Removing Cable From Module Band
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.