Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2002 Chevrolet Venture PlusSECTION Installation Procedure
- Align the rear object detection module to the vehicle.NOTE: Refer to FASTENER NOTICE .
- Install the rear object detection module mounting bolts.
Tighten
Tighten the bolts to 10 N.m (89 lb in).
- Install the electrical connector to the rear object detection module and press in locking tab.
- Install the rear compartment side trim. Refer to TRIM PANEL REPLACEMENT - REAR QUARTER LOWER .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.