Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002SILVERADO 1500 HD, RWDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROLS - SYSTEM & COMPONENT TESTINGFUEL SYSTEM (GASOLINE)FUEL INJECTOR BALANCE TEST WITH TECH 2 (2.2L SONOMA & S10 PICKUP)TEST DESCRIPTION
2002 Chevrolet Silverado 1500 HD, RWD
Test Description
2002 Chevrolet Silverado 1500 HD, RWDSECTION Test Description
The numbers below refer to step numbers in diagnostic procedure.
- 3
Engine Coolant Temperature (ECT) must be below operating temperature in order to avoid irregular fuel pressure readings due to hot soak fuel boiling. - 4
Fuel pressure should be within specified range. If fuel pressure is not within specified range, see FUEL SYSTEM PRESSURE TEST (2.2L SONOMA & S10 PICKUP) under BASIC FUEL SYSTEM CHECKS (GASOLINE) in BASIC DIAGNOSTIC PROCEDURES - TRUCKS - EXCEPT TRACKER article. - 5
Fuel pressure should reach a steady value. If fuel pressure does not stabilize, see FUEL SYSTEM PRESSURE TEST (2.2L SONOMA & S10 PICKUP) under BASIC FUEL SYSTEM CHECKS (GASOLINE) in BASIC DIAGNOSTIC PROCEDURES - TRUCKS - EXCEPT TRACKER article. - 6
If pressure drop value for each fuel injector is within 1.5 psi (10 kPa) of average pressure drop value, fuel injectors are flowing properly. Calculate pressure drop value for each fuel injector by subtracting second pressure reading from first pressure reading. See Figure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.