Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002SILVERADO 1500 HD, RWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEMREPAIR INSTRUCTIONSELECTRONIC BRAKE CONTROL MODULE (EBCM) REPLACEMENTINSTALLATION PROCEDURE
2002 Chevrolet Silverado 1500 HD, RWD
Installation Procedure
2002 Chevrolet Silverado 1500 HD, RWDSECTION Installation Procedure
Important
- Do not reuse the old mounting screws. Always install new mounting screws with the new EBCM.
- Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
- Install the EBCM (2) on to the BPMV (1).
- Install the new screws in the EBCM (2). Tighten the screws to 5 N.m (39 lb in) in an X-pattern.
- Install or tighten the EHCU bracket mounting bolts (4). Tighten the EHCU bracket mounting bolts to 25 N.m (18 lb ft).
- Connect the electrical connectors to the EBCM.
- Lower the vehicle.
- Connect the negative battery cable.
- Revise the tire calibration using the Scan Tool Tire Size Calibration function.
- Return to Diagnostic Starting Point - Anti-Lock Brake System .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.