Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002S10 PICKUP 2D PICKUP, 2.2 5, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 2 (SHIFT INTERLOCK SYSTEMS)REMOVAL & INSTALLATIONLOWER INSULATOR PANELINSTALLATION
2002 Chevrolet S10 Pickup 2D Pickup, 2.2 5, Standard
Lower Insulator Panel: Installation
2002 Chevrolet S10 Pickup 2D Pickup, 2.2 5, StandardSECTION Installation
WARNING: This page is about a different variant/trim than selected.
- Connect the electrical connector to the accessory power outlet, if equipped.
- Install the instrument panel sound insulator to the vehicle. See Fig 1. Install the screws that retain the instrument panel sound insulator to the knee bolster, instrument panel, and the floor duct. Tighten the screws to 13 INCH lbs. (1.5 N.m).
- Install the screw that retains the instrument panel sound insulator to the heater assembly. Tighten the screw to 13 INCH lbs. (1.5 N.m).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.