SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002S10 PICKUP 2D PICKUP, 2.2 5, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 2 (SHIFT INTERLOCK SYSTEMS)REMOVAL & INSTALLATIONLEFT INSULATOR PANELINSTALLATION
2002 Chevrolet S10 Pickup 2D Pickup, 2.2 5, Standard

Left Insulator Panel: Installation

2002 Chevrolet S10 Pickup 2D Pickup, 2.2 5, StandardSECTION Installation
WARNING: This page is about a different variant/trim than selected.
  1. Install the remote control door lock receiver module to the instrument panel sound insulator. Connect the electrical connector to the remote door lock receiver module. Install the screw that retains the instrument panel sound insulator to the cowl panel. Tighten the screw to 17 INCH lbs. (1.9 N.m).
  2. Install the screws that retain the instrument panel sound insulator to the knee bolster. See Fig 1. Tighten the screws to 17 INCH lbs. (1.9 N.m). Feed the DLC through the hole in the instrument panel sound insulator. Install the screws that retain the DLC to the instrument panel sound insulator. Tighten the screws to 21 INCH lbs. (2.4 N.m).
Fig 1: Removing & Installing Left Insulator Panel
G00082439Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.