Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002S10 PICKUP 2D PICKUP, 2.2 5, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 2 (SHIFT INTERLOCK SYSTEMS)REMOVAL & INSTALLATIONFLOOR SHIFT CONTROLINSTALLATION
2002 Chevrolet S10 Pickup 2D Pickup, 2.2 5, Standard
Floor Shift Control: Installation
2002 Chevrolet S10 Pickup 2D Pickup, 2.2 5, StandardSECTION Installation
WARNING: This page is about a different variant/trim than selected.
- Install the floor shift control to the floor panel. Install the nuts securing the shift controller to the floor panel. Tighten the nuts to 18 INCH lbs. (25 N.m). See Fig 3. Install shift lock solenoid connector. See Fig 4.
- Install the shift cable onto shift control. Install cable retainer clip. See Fig 2.
- Install the shift control cover. Install floor console, if equipped. See appropriate procedure.
- Install the gearshift lever handle and boot assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.