Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002S10 PICKUP 2D PICKUP, 2.2 5, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEWINDOWSSTATIONARY WINDOW SYSTEMREPAIR INSTRUCTIONSBODY SIDE STATIONARY WINDOW REPLACEMENT (UTILITY)INSTALLATION PROCEDURE
2002 Chevrolet S10 Pickup 2D Pickup, 2.2 5, Standard
Installation Procedure
2002 Chevrolet S10 Pickup 2D Pickup, 2.2 5, StandardSECTION Installation Procedure
- For the 2-door utility only, install a stationary window into the opening. Refer to Urethane Adhesive Installation of Stationary Windows .
- For the 2-door utility only, install 2 new rivets in order to secure the glass assembly to the sheet metal.
- Install 2 new rivets in order to secure the glass assembly to the sheet metal.
- For the 2-door utility only, install the rear seat belt anchor bolt to the roof.
- Install the body side trim panels. Refer to TRIM PANEL REPLACEMENT - BODY SIDE (STANDARD CAB PICKUP) or TRIM PANEL REPLACEMENT - BODY SIDE (EXTENDED CAB PICKUP) or TRIM PANEL REPLACEMENT - BODY SIDE (2-DOOR UTILITY) or TRIM PANEL REPLACEMENT - BODY SIDE (4-DOOR UTILITY) or TRIM PANEL REPLACEMENT - BODY SIDE (CREW CAB) in Interior Trim.
- Remove the double layer of masking tape around the perimeter of the painted surfaces and interior trim.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.