Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002S10 PICKUP 2D PICKUP, 2.2 5, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATSPOWER SEAT SYSTEMREPAIR INSTRUCTIONSEZ ENTRY SEAT MANUAL RELEASE KNOB REPLACEMENTINSTALLATION PROCEDURE
2002 Chevrolet S10 Pickup 2D Pickup, 2.2 5, Standard
Installation Procedure
2002 Chevrolet S10 Pickup 2D Pickup, 2.2 5, StandardSECTION Installation Procedure
- Install the release handle (2) to the seat back.NOTE: Refer to FASTENER NOTICE in GM VEHICLES CAUTIONS & NOTICES article.
- Install the retaining screw to secure the handle.
Tighten
Tighten the handle retaining screw to 1.5 N.m (14 lb in).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.