Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2002S10 PICKUP 2D PICKUP, 2.2 5, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEMIRRORSSTATIONARY WINDOW SYSTEMREPAIR INSTRUCTIONSWINDSHIELD SIDE REVEAL MOLDING REPLACEMENTREMOVAL PROCEDURE

2002 Chevrolet S10 Pickup 2D Pickup, 2.2 5, Standard

Removal Procedure

2002 Chevrolet S10 Pickup 2D Pickup, 2.2 5, StandardSECTION Removal Procedure

Peel back the weatherstrip tape in order to reveal the molding screws.
Remove the fasteners.
Remove the reveal molding from the windshield pillar.

Fig 1: Removing Fasteners And Reveal Molding From Windshield Pillar
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.