Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Chevrolet Prizm Base, StandardFACTORY OEM SERVICE PROCEDURE
Removal Procedure
- Remove the air cleaner assembly.
- Disconnect the EBCM harness connector (2).
- Remove the 6 brake pipes from the brake modulator assembly (3).
- Plug the brake pipes in order to prevent loss or contamination of brake fluid.
- Remove 3 nuts and the brake pressure modulator assembly (3) from the bracket (4).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
