Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002MONTE CARLO V6-3.8L VIN KREPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSTEERINGSTEERING COLUMNSERVICE AND REPAIRTURN SIGNAL & MULTIFUNCTION SWITCH - ASSEMBLE
2002 Chevrolet Monte Carlo V6-3.8L VIN K
Turn Signal & Multifunction Switch - Assemble
2002 Chevrolet Monte Carlo V6-3.8L VIN KSECTION Turn Signal & Multifunction Switch - Assemble
Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle
Notice: Refer to Fastener Notice in Service Precaution.
Important: The electrical contact of the turn signal and multifunction switch assembly must rest on the contact of the turn signal cancel cam assembly.
1. Install the turn signal and multifunction switch assembly and secure by using the 2 pan head tapping screws.
^ Tighten the screws to 7 Nm (62 inch lbs.).
2. Reconnect the connectors of the turn signal and multifunction switch assembly.
Caution: Refer to SIR Inflator Module Coil Caution in Service Precautions.
3. Install the new wire harness straps onto the wire harness assembly (1).
4. Install the wire harness assembly (1) into the wire harness strap (2).
5. Install the upper and lower trim covers.
6. Enable the inflatable restraint steering wheel module.
Notice: Refer to Fastener Notice in Service Precaution.
Important: The electrical contact of the turn signal and multifunction switch assembly must rest on the contact of the turn signal cancel cam assembly.
1. Install the turn signal and multifunction switch assembly and secure by using the 2 pan head tapping screws.
^ Tighten the screws to 7 Nm (62 inch lbs.).
2. Reconnect the connectors of the turn signal and multifunction switch assembly.
Caution: Refer to SIR Inflator Module Coil Caution in Service Precautions.
3. Install the new wire harness straps onto the wire harness assembly (1).
4. Install the wire harness assembly (1) into the wire harness strap (2).
5. Install the upper and lower trim covers.
6. Enable the inflatable restraint steering wheel module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.