Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002IMPALA LSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALSTARTERSTARTING SYSTEMDIAGNOSTIC INFORMATIONSTARTER SOLENOID CLICKS, ENGINE DOES NOT CRANK
2002 Chevrolet Impala LS
Starter Solenoid Clicks, Engine Does Not Crank
2002 Chevrolet Impala LSSECTION Starter Solenoid Clicks, Engine Does Not Crank
- Did you perform the DIAGNOSTIC SYSTEM CHECK - ENGINE ELECTRICAL? If so, go to next step. If not, go to DIAGNOSTIC SYSTEM CHECK - ENGINE ELECTRICAL .
- Turn the ignition switch to the START position. Did the starter solenoid click one time? If so, go to next step. If not, go to STARTER SOLENOID DOES NOT CLICK .
- Inspect the engine and belt drive system for mechanical binding (seized engine, seized generator). Does the engine move freely? If so, go to next step. If not, go to ENGINE WILL NOT CRANK - CRANKSHAFT WILL NOT ROTATE .
- Test the battery positive cable between the battery and the Engine Harness Wiring Junction Block (TOP) for an open or high resistance. Did you find and correct the condition? If so, go to step 10 . If not, go to next step.
- Test the battery positive cable between the Engine Harness Wiring Junction Block (TOP) and the starter motor for an open or high resistance. Did you find and correct the condition? If so, go to step 10 . If not, go to next step.
- Test the ground of the starter motor between the battery and the starter motor for a high resistance. Did you find and correct the condition? If so, go to step 10 . If not, go to next step.
- Inspect for poor connections at the Engine Harness Wiring Junction Block (TOP). Did you find and correct the condition? If so, go to step 10 . If not, go to next step.
- Inspect for poor connections at the starter motor. Did you find and correct the condition? If so, go to step 10 . If not, go to next step.
- Replace the starter motor. See STARTER MOTOR . After replacement is complete, go to next step.
- Operate the system in order to verify the repair. Did you find and correct the condition? If so, then system is okay. If not, go to step 2 .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.