Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002IMPALA LSREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALCHARGING SYSTEMSREMOVAL & INSTALLATIONGENERATORREMOVAL (3.8L)
2002 Chevrolet Impala LS
Removal (3.8L)
2002 Chevrolet Impala LSSECTION Removal (3.8L)
NOTE:
Delphi CS130D (K68) 105-amp generator is serviced as a complete unit only.
- Disconnect negative battery cable.
- Remove drive belt from generator.
- Remove generator rear brace.
- Remove bolts (1, 3) and stud (2) from generator. See Fig 1 .
- Disconnect electrical connector from generator.
- Position aside protective boot from generator output BAT terminal for access.
- Remove generator output BAT terminal nut and remove positive battery cable from generator.
- Remove generator.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.