SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002IMPALA LSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESBODY CONTROL MODULESREMOVAL & INSTALLATIONHVAC CONTROL MODULEREMOVAL (MONTE CARLO)
2002 Chevrolet Impala LS

Removal (Monte Carlo)

2002 Chevrolet Impala LSSECTION Removal (Monte Carlo)
  1. Remove instrument panel cluster trim plate. See INSTRUMENT PANEL CLUSTER TRIM PLATE .
  2. Apply park brake. Place transaxle shift lever in 2nd gear. Remove front floor console trim plate screw located between instrument panel and shift lever. See Fig 1.
  3. Open storage compartment door. Lift trim plate up and slightly rearward. Remove wiring harnesses from retainers. Disconnect traction control switch electrical connector. Remove shift lever trim plate. Disconnect heated seat switches from trim plate. Remove trim plate by lifting trim plate slightly and rotating trim plate 180 degrees. Lift trim plate over shift control handle. See Fig 2. Disconnect electrical connector from cigarette lighter.
  4. Disconnect wiring harness connector and retainer. Open console storage compartment. Remove storage compartment mat. Remove bolts from bottom of storage compartment. Remove console bolts forward of shift control lever. Remove front floor console. See Fig 3.
  5. Remove retaining screws from HVAC control module. Pull HVAC control module out from instrument panel. Disconnect electrical connectors from HVAC control module. Disconnect vacuum connectors from HVAC control module. Remove HVAC control module from instrument panel.
Fig 1: Identifying Front Floor Console Trim Plate Screw (Monte Carlo)
G00072315Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.