Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2002CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 8.1 GREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATSSEAT SYSTEMREPAIR INSTRUCTIONSSEAT REPLACEMENT - REAR BENCH (ALL EXCEPT LUXURY)INSTALLATION PROCEDURE

2002 Chevrolet Chevy Express G3500, Van Passenger Extended, 8.1 G

Installation Procedure

2002 Chevrolet Chevy Express G3500, Van Passenger Extended, 8.1 GSECTION Installation Procedure

Install the seat to the vehicle.

Fig 1: Installing Seat
Courtesy of GENERAL MOTORS CORP.
Align the seat attaching points with the slots in the floor rail.
Push the seat forward in the rail in order to lock the front of the seat risers onto the pins on the inside of the floor rail.

Fig 2: Locking Seat Risers Onto Pins
Courtesy of GENERAL MOTORS CORP.
Remove the locking pin (3) from the stored position at the rear of the seat riser (2).

Fig 3: Removing Locking Pin From Stored Position
Courtesy of GENERAL MOTORS CORP.
Locate the hole in the floor rail at the rear of the seat riser (2) and insert the locking pin.
Rotate the locking pin (3) at the rear of the seat riser (1) into the retaining clip.
Insert the latch plate into the seat belt buckle in order to install the quick release latch plate for the lap/shoulder belt.
Push in order to engage the latch plate with the seat belt buckle.

Fig 4: Inserting Locking Pin

Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.