Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002CHEVY EXPRESS G3500, VAN PASSENGER EXTENDED, 8.1 GREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEEXTERIOR BODY PANELSBODY FRONT ENDREPAIR INSTRUCTIONSHOOD LATCH RELEASE CABLE REPLACEMENTINSTALLATION PROCEDURE
2002 Chevrolet Chevy Express G3500, Van Passenger Extended, 8.1 G
Installation Procedure
2002 Chevrolet Chevy Express G3500, Van Passenger Extended, 8.1 GSECTION Installation Procedure
- Position the cable (1) to the vehicle.
- Route the cable (1) from the cabin into the engine compartment.
- Install the cable grommet into the front of dash.
- Install the cable handle (3) to the hinge pillar.
- Install the screws to the hood release handle (3) to the pillar.
- Install the left side hinge pillar trim panel to the body. Refer to TRIM REPLACEMENT - HINGE PILLAR .
- Install the cable (1) to the retainer on the radiator support.
- Install the cable (1) to the hood latch.
- Close the hood.
- Inspect the hood release cable for proper operation.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.