Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002CAVALIER BASE, 4D SEDAN, 2.4 TREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLANTI-LOCK BRAKE SYSTEMREPAIR INSTRUCTIONSELECTRONIC BRAKE CONTROL MODULE (EBCM) REPLACEMENTINSTALLATION PROCEDURE
2002 Chevrolet Cavalier Base, 4D Sedan, 2.4 T
Installation Procedure
2002 Chevrolet Cavalier Base, 4D Sedan, 2.4 TSECTION Installation Procedure
- Clean the EBCM gasket and the BPMV surface with alcohol using a clean rag.
- Install the EBCM (1) to the BPMV (2).NOTE: Refer to Fastener Notice in Cautions and Notices.
- Install the four screws that attach the EBCM (1) to BPMV (2).
Tighten
Tighten the four screws to 5 N.m (44 lb in).
- Connect the EBCM harness connector (4).
- Push down the harness connector lock tab and then move the sliding connector cover back in the home position to lock.
- Push the CPA (2) back into place.
- Perform the Diagnostic System Check. Refer to DIAGNOSTIC SYSTEM CHECK - ABS .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.