Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002CAVALIER BASE, 4D SEDAN, 2.4 TREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEIGNITION SWITCH/STEERING LOCKSTEERING WHEEL & STEERING COLUMNREMOVAL & INSTALLATIONSEAL REPLACEMENT - INTERMEDIATE STEERING SHAFTINSTALLATION PROCEDURE
2002 Chevrolet Cavalier Base, 4D Sedan, 2.4 T
Installation Procedure
2002 Chevrolet Cavalier Base, 4D Sedan, 2.4 TSECTION Installation Procedure
CAUTION:
If steering column to cowl panel seal is torn or otherwise damaged, it must be replaced. Confirm that the seal and inner race are properly located. Failure to do so may allow carbon monoxide into the vehicle, which may result in serious personal injury or death.
- Install the intermediate steering shaft seal to the vehicle.
- Position the intermediate steering shaft seal on the front of dash panel.
- Install the intermediate steering shaft.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.