Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2002CAVALIER BASE, 4D SEDAN, 2.4 TREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTING SYSTEMSDIAGNOSTIC INFORMATION & PROCEDURESDTC B2532: FOG LAMP RELAY CONTROL CIRCUIT IS OPEN OR SHORTED TO GROUNDTEST DESCRIPTION
2002 Chevrolet Cavalier Base, 4D Sedan, 2.4 T
Test Description
2002 Chevrolet Cavalier Base, 4D Sedan, 2.4 TSECTION Test Description
The numbers below refer to the step numbers on the diagnostic table.
- 2) - Listen for an audible click when the fog lamp relay operates. Command both the ON and OFF states. Repeat the commands as necessary.
- 3) - Tests for voltage at the coil side of the fog lamp relay.
- 4) - Verifies that the body control module is providing ground to the fog lamp relay.
- 5) - Tests if ground is constantly being applied to the fog lamp relay.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.